Page 1 of 1

Need help with editor

Posted: Fri May 25, 2018 8:18 pm
by Animeous
So I spend good half an hour trying to understand how the railguns are supposed to turn and I still can't figure it out. I can't make sense of it. The wiki didn't help. Pls help

Re: Need help with editor

Posted: Fri May 25, 2018 10:28 pm
by BlueTheKing
Here's my attempt at trying to explain this, if you have any extra questions just ask.

Image
Both the X and Y start on the right and go clockwise.

Image
The values you put in are how many degrees the lines will turn clockwise.

Image
You can keep doing this until you get your desired turning range.

If you enter negative values the line will turn counter-clockwise.

Re: Need help with editor

Posted: Sat May 26, 2018 12:57 am
by Warhawk
The above is a great start.

The one thing that will mess you up most is that changing the Y value after you've changed X results in X resizing down and screwing up your angle, because X must always be less than Y. Work backwards when you do: Enter Y first, then X, and it'll look exactly as you need it.