Hello guys !

After have done a map i realized that outside gate A and gate B there were not lights :/
I saw in the editor in the map already made that there is a kind of cube around gate a and gate b, i think its the sky :/

How can i correct this ? how can i place the sky in the end part ?

Thank you ;)

Alphive wrote:Hello guys !

After have done a map i realized that outside gate A and gate B there were not lights :/
I saw in the editor in the map already made that there is a kind of cube around gate a and gate b, i think its the sky :/

How can i correct this ? how can i place the sky in the end part ?

Thank you ;)

What do you mean, "there were not lights"? Do you mean the area wasn't illuminated? There was no light, it was dark? If so, you might have turned the facility's lighting off at the Control Center where you can disable/enable the doors. I'm guessing Reg was really lazy about this, but when you turn secondary and primary lighting off, and go to one of the gates-outside zone, the outside world is dark, like it's still in the facility.

If you mean the gates themselves, then those rooms are always off, and are usually illuminated with one or two red lights. Gate B on the other hand, is illuminated from the inside.

tl;dr - Shut off facility's lights, facility and outside has no light.

Alphive wrote:Hello guys !

After have done a map i realized that outside gate A and gate B there were not lights :/
I saw in the editor in the map already made that there is a kind of cube around gate a and gate b, i think its the sky :/

How can i correct this ? how can i place the sky in the end part ?

Thank you ;)

Are you referring to the bug where the actual room2gateb/a doesn't render when right outside it?